Designed to be installed on the fans discharge side. The minimum air speed through the heater must be 1,5 m/s.
Maximum air temperature through the heater: 40ºC.
The heaters are fitted with:
– Armoured heating element.
– Double protection circuit to connect to the heater control circuit by means of a safety overheat automatic thermostat connected in series with another safety overheat manual reset thermostat (RESET).
– Wiring box IP43.
Available temperature sensors in the duct, ambient temperature sensors and speed controllers to complete the installation and to adjust the air temperature according to every need.

Designed to be installed on the fans discharge side.
The minimum air speed through the heater must be 2 m/s.
Maximum air temperature through the heater: 40ºC.
The heaters are fitted with:
– Armoured heating elements to connect to the three phase net (3×400).
– Double protection circuit to connect to the heater control circuit by means of a safety overheat automatic thermostat (60º), connected in series with another safety overheat manual reset thermostat (RESET).
– Wiring box IP43.
Available temperature sensors in the duct, ambient temperature sensors and speed controllers to complete the installation and to adjust the air temperature according to every need.
By means of this system the supplied air can reach up to 50º.
(See the electrical accessories section).

To provide fan assisted heating to workshops, commercial environments and it is also designed appliance for fireplace. It prepares the chimney for an effortless process of starting a fire.

Characteristics
IP20.
Made of steel sheet with a paint coating.
Quiet axial fan.
Switch ON/OF.
Adjustable support feet.
Rubber supports allowing to insert the FIRE FAN on the floor of a chimney.
Thermal protection.

To provide fan assisted heating to commercial or industrial environments, or for drying applications.

Characteristics
IP24.
Made of steel sheet with a paint coating.
Fitted with a handle to move it.
Quiet axial fan.
Switch enabling an adjustment of the extraction or heating of the units (only fan function; fan and low heating and fan and high heating operation).
Thermostat allowing the setting of the desired temperature of the room.
Rear switch that allows the thermostat to act on both the fan and the heater element or only on the heater (the fan operates permanently).
Contactor.
Thermal protection.
Manual self resetting button (RESET).